Blog

Manual-based CRS90G cleaning guidance covering power isolation, prohibited cleaning methods, door-seal care, food storage and condenser work.

The goal of this blog is to educate readers on the importance of using blue plasters in catering environments, explaining their purpose, legal requirements, and benefits for food safety.

Disconnect the HVR21B from the power outlet before cleaning. Use a soft cloth with lukewarm water, adding only diluted neutral kitchen detergent for stubborn dirt, then remove residue and dry the surfaces. Avoid water spray, abrasive cleaners and chemical mixtures. Clean seals promptly, treat ventilation openings gently and leave damage or internal work to an authorised service centre.

The WB12 is for trained operators. Start by connecting and turning on the water, then visually check accessible pipes and connections for leaks before connecting power. Keep the steam release outlet unobstructed, never open the drain while the unit is in use or hot, and leave overload resets and internal faults to qualified service. Disconnect power for cleaning, use a wet towel, and avoid hosing, caustic chemicals and abrasives.

A source-locked AD10 guide to selecting the dough arm, beater or wire whip, observing the stated capacity and changing attachments with the mixer stopped.

For a trained operator, the EGA-1 permits a tightly limited burner-reset sequence: press the external red burner reset button once. Only if the red warning light remains on may the button be pressed one further time after “a few minutes”. If the burner still does not ignite, stop resetting and contact the technical service centre. If it ignites but then repeatedly goes out, do not cycle the reset: the manual provides no separate operator repair procedure for recurring shutdown, so refer it to technical service. [EGA1-20-01, EGA1-21-02, EGA1-21-03, EGA1-21-04, EGA1-19-01]

Hold SET for three seconds until the °C symbol flickers, adjust the displayed value with the arrow buttons, and release the buttons to set the new temperature. This guide covers only the normal operator controls documented for the TEFCOLD GUC70.

A source-locked guide to editing and saving an existing recipe in the Lincat CiBO Recipe Manager, with clear limits around CiBO+ and food-safety validation.

A source-locked cleaning guide that separates manual cleaning from the powered automatic cycle and escalates ambiguous internal maintenance to qualified personnel.

Check the Combisteel 7013.2570’s external power supply, installation clearance, location, door closure and operator temperature setting before escalating. Do not open the appliance or attempt electrical, refrigerant or sealed-system diagnosis.